Fall special · Tulsa metro
Fall furnace tune-up for $69
Updated November 19, 2026
Your furnace has been sitting since spring. We’ll test it for carbon monoxide, clean the parts that fail first, and make sure it lights on the first cold night. One flat price per system, with a written report when we’re done.
Gas furnaces, heat pumps and dual-fuel systems. Mon–Sat 7 AM–8 PM.
Why fall
Most no-heat calls are small parts that quit after a long summer
Tulsa furnaces sit idle from about April to October. In that time, igniters develop hairline cracks, flame sensors build up oxide, and pressure switch hoses dry out. None of that shows up until the thermostat calls for heat on the first cold night, and that is exactly when everyone else is calling too.
The part of the tune-up that matters most is the one you can’t see: the heat exchanger. A crack there can leak carbon monoxide into the air you breathe. We measure CO at the supply vents and flue and inspect the heat exchanger before we sign off on any furnace.
Heat pumps work harder here than most people expect, switching between heating and defrost all winter. A fall check confirms the defrost cycle, the reversing valve and the backup heat strips before you need them.
What’s included
Everything we check for $69
The same checklist on every visit, so you know exactly what you’re paying for.
Safety
- Carbon monoxide reading at supply vents and flue
- Heat exchanger inspection for cracks
- Flue, venting and combustion air path
- High-limit and rollout safety switch tests
Ignition and burners
- Igniter tested, flame sensor cleaned
- Gas pressure measured at the manifold
- Burner flame and cleanliness
- Inducer motor and pressure switch operation
Airflow and electrical
- Blower motor amp draw and blower wheel check
- Filter condition and size
- Electrical connections tightened
- Thermostat operation and temperature rise
Heat pumps
- Defrost cycle and reversing valve
- Backup and emergency heat strips
- Refrigerant pressures in heating mode
- Outdoor coil, drainage and clearance
The $69 price covers one system and the inspection, cleaning and adjustments above. Parts and repairs are extra and always quoted first.
How it works
Booked in a minute, done in about an hour
Pick a time
Book online or call 918-200-9111. Same-day and next-day slots are often available.
We tune it up
A licensed, EPA-certified tech works through the checklist. Most visits take 60 to 90 minutes.
You get the report
The readings and anything worth watching. If a part needs replacing, you see the price before we touch it.
PSO customers
Heat pump on PSO? Ask about the tune-up rebate
PSO has paid rebates on qualifying heat pump tune-ups done by participating contractors. Program rules change, so we check your account and equipment before the visit and tell you up front whether a rebate applies.
Thinking about replacing an older system instead? See how PSO rebates and Hearth financing can lower the cost, or read our fall furnace checklist first.
Questions
Fall tune-up FAQ
What does the $69 fall tune-up include?
One furnace or heat pump, fully checked: carbon monoxide test, heat exchanger inspection, igniter and flame sensor service, gas pressure, burners, inducer and pressure switch, safety limit tests, blower amp draw, filter check, electrical connections and thermostat operation. Heat pumps also get a defrost, reversing valve and backup heat strip check. You get a written report at the end.
Is the $69 price per house or per system?
Per system. A home with one furnace pays $69. If you have two systems, such as an upstairs and downstairs unit, each one is $69.
Are repairs or parts included in the $69?
No. The tune-up covers the inspection, cleaning and adjustments listed on this page. If we find a part that needs replacing, we show you what we found and quote the repair before doing any work. You decide.
When should I get my furnace tuned up in Tulsa?
Before the first hard freeze. Tulsa furnaces sit unused from roughly April through October, and igniters, flame sensors and pressure switch hoses tend to fail on the first cold night. If you missed early fall, it is still worth doing now, before the January cold snaps.
How long does a fall tune-up take?
Most visits take 60 to 90 minutes per system. Older furnaces or attic installs can take a little longer.
Can PSO customers get a rebate on a heat pump tune-up?
PSO has offered rebates on qualifying heat pump tune-ups performed by participating contractors. Program rules and amounts change, so we check your PSO account and equipment before the visit and tell you if a rebate applies.
Do you service gas furnaces and electric heat pumps?
Yes. The fall tune-up covers gas furnaces, electric furnaces, heat pumps and dual-fuel systems across the Tulsa metro, including Broken Arrow, Owasso, Bixby, Jenks, Sand Springs, Sapulpa, Claremore and Catoosa.
Get your heat checked before the first hard freeze
$69 per system. Tulsa, Broken Arrow, Owasso, Bixby, Jenks, Sand Springs, Sapulpa, Claremore, Catoosa and Sperry.